03-07-2025, 12:41 PM
(This post was last modified: 03-07-2025, 08:51 PM by quattrodave.
Edit Reason: more info
)
Manually pulling EN to ground does reboot Afterburner.
I've set GPIO to 'user' and 'digital'.
Set the timers, they do activate at the set time but cannot get the timers to activate the GPIO out 1...
The GPIO outputs definatly work, I tested with a multimeter & heater run status settings.
Checked the firmware and its running 3.5.2 2nd July 24...
Am I being a numpty, is there anything i've missed....?
Thanks
EDIT:
I've updated the firmware to the latest BETA V3.5.2.11... GPIO is working perfectly & the auto reboot is working perfectly :-D Thank you!
I'll test the MQTT & WIFI for a few days and report back.....
I've set GPIO to 'user' and 'digital'.
Set the timers, they do activate at the set time but cannot get the timers to activate the GPIO out 1...
The GPIO outputs definatly work, I tested with a multimeter & heater run status settings.
Checked the firmware and its running 3.5.2 2nd July 24...
Am I being a numpty, is there anything i've missed....?
Thanks
EDIT:
I've updated the firmware to the latest BETA V3.5.2.11... GPIO is working perfectly & the auto reboot is working perfectly :-D Thank you!
I'll test the MQTT & WIFI for a few days and report back.....