I tried again the upload, but it does not support MP4...
So I uploaded it to youtube and insert it here
As it is in actual use, and the issue is only once in a while, I prefer not to solder...
So I uploaded it to youtube and insert it here
(10-24-2024, 07:43 PM)afterburner Wrote: Being a BETA, I hope you do have to hand a FTDI (or similar) USB to serial adapter.
It would be best to attach that to the debug serial port (Tx to Rx, Rx to Tx, ie a direct plug onto the port if the connectors were amenable) and then capture the emitted output as the unit boots. There with luck what is happening at the point of reboot becomes more evident...
The Serial port runs @ 115200, 8 data , No parity, 1 stop bit.
Using the serial port, you can also roll back to the release firmware as well.
The process is described @ http://afterburner.mrjones.id.au/firmware.html#Serial
As it is in actual use, and the issue is only once in a while, I prefer not to solder...