10-19-2024, 11:34 PM
(This post was last modified: 10-20-2024, 12:08 AM by afterburner.
Edit Reason: highlighting
)
Correct, you simply wire (up to 3) sensors in parallel.
You MUST reboot the Afterburner.
Then use the System Settings - DS18B20 Sensor Order menu to assign a priority to the new sensors.
If they have a -?- against them, they will not be usable by the AB (ala not assigned yet).
This effectively names them Sensor1, 2, or 3.
THEN make sure you visit the nearby Thermostat Sensor menu to nominate which of all sensors should be used for the thermostat role.
The very latest BETA firmware also allows you to enter names for each sensor via the keypad, to replace the default Sensor1, etc.
Otherwise you can use the Android App or Web Page to do this (less convoluted!)
You MUST reboot the Afterburner.
Then use the System Settings - DS18B20 Sensor Order menu to assign a priority to the new sensors.
If they have a -?- against them, they will not be usable by the AB (ala not assigned yet).
This effectively names them Sensor1, 2, or 3.
THEN make sure you visit the nearby Thermostat Sensor menu to nominate which of all sensors should be used for the thermostat role.
The very latest BETA firmware also allows you to enter names for each sensor via the keypad, to replace the default Sensor1, etc.
Otherwise you can use the Android App or Web Page to do this (less convoluted!)