03-03-2025, 02:11 PM
(This post was last modified: 03-03-2025, 02:14 PM by quattrodave.)
Thanks for your reply. Sure, that makes sense. OK, I think I follow your logic, your suggesting using GPIO out 1 to pull EN to ground to cause a reboot... so couple of questions here...
1. GPIO Output#1 (Orange) looped back to 'EN' the physical push button on the board ?
2. Create a repeating timer say 3am every day to activate GPIO Output#1 ?
3. I've just been going through the manual, what setting would I use for the GPIO Output#1 ?
4. Would it be OK to 'reboot' Afterburner this way whilst the heater is running ?
1. GPIO Output#1 (Orange) looped back to 'EN' the physical push button on the board ?
2. Create a repeating timer say 3am every day to activate GPIO Output#1 ?
3. I've just been going through the manual, what setting would I use for the GPIO Output#1 ?
4. Would it be OK to 'reboot' Afterburner this way whilst the heater is running ?